Installation instruction: EQC / EP-UNIVERSAL PRIMER

Go back to product info

Tools

  • primer/nylon roller
  • drill with mixing spindle attachment
  • gloves

Mixing

  • Measure the moisture content of the substrate: max 5%
  • make sure the floor is free of dust and grease and that any loose particles have been removed
  • tape the edges to a sufficient height to prevent splashes
  • Check you have sufficient A & B material (for consumption, see label)

Mix

  • Combine the A and B component in the correct proportion (see label)
  • mix for 2 minutes using a drill with mixing spindle attachment

 

 

Application: scatter

Pour the mixture onto the floor and spread evenly with a nylon roller, brush, window/floor squeegee

Application: remove excess sand

Depending on the system to be placed on top of the primer, +/-5 minutes after application you can scatter fire-dried sand

  • for flat roll coatings, waterproofing membrane, scratch coat: do not scatter
  • for mortar floors
      • 0.1-0.3 mm or,
      • 0.4-0.8 mm
  • For stone and marble carpet:
      • 0.4-0.8 mm
  • For anti-slip floor depending on desired effect:
      • 0.4-0.8 mm ,or
      • 0.8-1.2 mm, or
      • carbodura 0.5-1.0 mm

Cleaning tools

Remove the excess sand after drying (+/- 16 hrs at 20°C

  • Note: Check the scattered sand has firmly fixed everywhere. If the substrate is too porous, the primer may be completely absorbed, resulting in the sand not sticking. In this case, apply an extra layer!

Cleaning tools

  • Used rolls cannot be reused.
  • Empty packaging: cured material or if scraped => construction waste, otherwise => chemical waste
  • Clean mixing spindle attachment with acetone

Additional points of interest

  • Caution: mixed product reacts quickly in the bucket and can become very hot and cause noxious fumes. Therefore, it is recommended to put the bucket outside if it is not empty after 10 minutes.
  • Note: Check the scattered sand has firmly fixed everywhere. If the substrate is too porous, the primer may be completely absorbed, resulting in the sand not sticking. In this case, apply an extra layer!

Video

Disclaimer

These brief installation instructions are here to get you started quickly during installation. However, it is important to first read the technical data sheet and to take note of the safety data sheets It is useful to read through the technical information, “Working with epoxy”. All of these documents can be found at the bottom of this page under downloads.

Downloads

Public downloads

  🇳🇱 🇫🇷 🇬🇧 🇩🇪
TDS

NL

FR

EN

DE

MSDS A

NL

FR

EN

DE

MSDS B

NL

FR

EN

DE

Contact our Sales Team and order now.

Contact our Sales Team and order now.