EP-SCRATCH COAT (2K)

Preparation

• Drill with mixing spindle attachment
• gloves
• flat trowel or toothed comb
• adhesive tape

Mixing

• Check there is enough product available
• Make the floor dust and grease free
• Mask off if necessary
• Avoid spilling the product

Mixing

• Combine the A and B components in the correct proportion (see label)
• mix for 2 minutes
• Pour into large mixing bucket
• Mix until homogeneous

Cleaning

• Pour 1.77-8.85 kg/m² of product onto the floor
• Spread immediately with a comb or trowel
• Rolling with a pin roller is normally not necessary, but it is recommended if the following defects are caused by, for example, poor surface preparation:

• • • • • Cratering
        • Small level differences
        • Decreased flow
        • Foaming

This can be done after ±15min. wearing pin shoes

• If necessary after 24 to 48h a 2the coat

Additional points of attention

• Clean with acetone

Disclaimer

Video

Disclaimer

These brief installation instructions are provided to help you quickly get started with the installation. However, it is important to first read the technical data sheet and to take note of the safety data sheets It is useful to read through the technical information, “Working with epoxy” All these documents can be found at the bottom of this page under downloads.