QC EP-BINDER 030

Tools

• drill with mixing spindle
• gluing trowels
• plant sprayer
• gloves

Preparation

• Check whether there is sufficient A and B component present (consumption see label)
• Always work on a sanded primer

Mixing

• For jerry cans and barrels: Shake the B component before mixing.
  • Combine the A and B components in the correct ratio (see label)
  • For small sets, there is enough space to pour the B component into the A component
• For large packages: Weigh the A and B components in separate buckets and then combine. Allow the mixing bucket to drain in between.
• Mix for 2 minutes using a drill with a mixing spindle
• Put the granulates in a mixing tub or forced mixer, add the mixed epoxy as quickly as possible and mix again

Application

• Spread on floor and spread immediately
• If necessary, remove excess resin from the tub
• Press/compact well

Cleaning of tools

• Empty packaging: cured material
  • other => chemical waste
• Cleaning tools with acetone

Points of attention

• Mixed product reacts quickly in the bucket and can become very hot and cause harmful fumes. It is therefore recommended to put the bucket outside if it is not empty after 10 minutes.
• In warm weather, clean the mixing bucket and tub regularly or use new ones
• Always mix for the same amount of time (chronometer), this will prevent any stains due to more or less erosion on the grains.

Preservation and storage

Shelf life: 12 months in a closed and original packaging when stored in a dry and cool place (10-25°C).

Safety measures

Read safety data sheets carefully before using QC EP-BINDER 030. Always wear personal protective equipment in accordance with local regulations and legislation. Gloves and safety glasses are mandatory.

Video

Disclaimer

These concise installation instructions are intended to help you get started quickly during installation. However, it is important to first read the full technical data sheet and to take note of the safety data sheets. It is also useful to read the technical information “working with epoxy”. You can find all these documents at the bottom of this page under downloads.