EP-TOPCOAT

Preparation

• 11 mm microfibre roller
• drill with mixing spindle attachment

Mixing

• Check there is enough product available
• Wear clean clothes and overshoes
• Tape off edges
• Remove any fluff or other foreign objects from microfibre roller using tape
• Cleaning the floor from dust and grease

Mixing

• Combine the A and B component in the correct proportion (see label)
• mix for 2 minutes using a drill with mixing spindle attachment
• Scrape walls of mixing container as you go along
• in hot weather, up to a maximum of 5% water may be added to prevent too rapid drying

Cleaning

• Saturate roll with ±400 g of product
• Apply evenly left-right, 120-180 g/m²
• Roll and lift backwards and forwards
• Remove tape before curing

Additional points of attention

• Clean with water

Disclaimer

Note:

• Do not roll too fast to avoid splashes
• Do not use in wet areas or outdoors

Video

Disclaimer

These brief installation instructions are provided to help you quickly get started with the installation. However, it is important to first read the technical data sheet and to take note of the safety data sheets Both documents can be found at the bottom of this page under downloads.