Brief installation instructions: MORTAR PA-CLEAR FILLER

Preparation

• drill with mixing spindle attachment
• white window or floor squeegee
• Nylon roll
• gloves

Mixing

• Before applying, check for stones above the desired surface and, if necessary, loosen them and remove them along with any other loose stones.
• cover the edges with tape
• check you have sufficient A & B material (for consumption, see label)

Mixing

• combine the A and B component in the correct proportion (see label)
• mix for 2 minutes using a drill with mixing spindle attachment.

Re-rolling

1. Usage blunt nail shoes (or stick coarse sandpaper under a clean shoe) to walk on the wet layer
2. Pour one SMALL part out on the floor
3. spread out using a transparent or white window squeegee or floor squeegee

2nd coat/layer

• leave min 10min after wiping
• use blunt nail shoes or stick coarse sandpaper under a clean shoe to go through the wet layer
• use a saturated nylon roll of x mm to roll after
  • • saturate the roller with +/-400g of material in roller tray
• roll crosswise
• as the final rolling motion, roll the roller forward without applying pressure. Do not pull the roller back but lift it in a fluid motion so as not to make the roller inserts visible

2nd layer

• After applying the first layer Wait 10 min to apply the 2nd layer
• repeat the previous 2 steps

Additional points of attention

• Used rollers and wipers cannot be reused.
• Empty packaging: cured material or scrapings => construction waste, otherwise => chemical waste
• Clean mixing spindle attachment with acetone

Disclaimer

Because the reaction speed of the Mortar PA-Clear Filler is determined by both moisture and temperature, it is important that only a small amount is applied to the floor at a time (otherwise the material may already start to react and thicken). As soon as this work has been completed, pour the next bucket out.

Video

Disclaimer

These brief installation instructions are provided to help you quickly get started with the installation. However, it is important to first read the technical data sheet and to take note of the safety data sheets Both documents can be found at the bottom of this page under downloads.