PA-RAPID SEALCOAT

Tools

• drill with mixing spindle attachment
• gloves
• white floor squeegee
• nylon roll
• adhesive tape

Preparation and processing

MIXING

• Mix the A-component at low speed before mixing
• Add the A- and B-components together in the correct ratio for 1 min.
• Pour some of the mixture into a separate bucket and use this to seal skirting boards and drains.

APPLICATION

• Check if there is enough product.
• Wear clean clothing and overshoes.
• Tape off edges and de-lint nylon roll with tape.
• Tape off the sides, skirting boards and drain holes.
• Then pour out PA-Rapid Sealcoat and spread with a squeegee.
• Remove the masking tape and roll out with an epoxy roller from front to back and lift up
• Remove the tape in sequence

Points of attention

• Processing time: Due to the rapid curing, rolling out PA-Rapid Sealcoat becomes more difficult after 15 min. after application. Ensure that there are always less than 15 min. between connections.
• Ideal conditions are a floor and ambient temperature of 18-22°C and humidity between 40% and 60% RH.
• Once the entire floor has been rolled out, the floor may no longer be walked on.
• B-component can be closed again by holding the can upside down for 15 sec. (without loss of properties).

Cleaning tools

Clean used tools with Cleaner EP or acetone. Cured product residues must be removed mechanically.

Preservation and storage

• Shelf life: 12 months in a closed and original container when stored in a dry and cool place (10-25°C).

Video

Disclaimer

These brief installation instructions are here to get you started quickly during installation. However, it is important to first read the technical data sheet and to take note of the safety data sheets Both documents can be found at the bottom of this page under downloads.