QC EP-BINDER 030

Tools

• drill with mixing spindle
• gluing trowels
• plant sprayer
• gloves

Substrate inspection

• Check whether there is sufficient A and B component present (consumption see label)
• Always work on a sanded primer

Preparation and processing

MIXING

• For jerry cans and barrels: Shake the B component before mixing.
• Add the A and B components together in the correct ratio (see label) for small sets there is enough space to pour the B component into the A component for large packages: weigh the A and B components in separate buckets and then add them together. Allow the mixing bucket to drain in between.
• Mix for 2 minutes using a drill with a mixing spindle
• Put the granulates in a mixing tub or forced mixer, add the mixed epoxy as quickly as possible and mix again

APPLICATION

• Distribute on the floor and spread immediately
• If necessary, remove excess resin from the tub
• Press/compact well

Points of attention

• Mixed product reacts quickly in the bucket and can become very hot and cause harmful fumes. Therefore, it is recommended to put the bucket outside if it is not empty after 10 minutes.
• In warm weather, clean the mixing bucket and tub regularly or use new ones
• Always mix for the same amount of time (chronometer), this prevents possible stains due to more or less erosion on the grains.

Cleaning

• Empty packaging: cured material
  • other => chemical waste
• Cleaning tools with acetone

Preservation and storage

Shelf life: 12 months in a closed and original packaging when stored in a dry and cool place (10-25°C).

Video

Disclaimer

Read the safety data sheets carefully before using QC EP-BINDER 030. Always wear personal protective equipment in accordance with applicable local guidelines and legislation. Gloves and safety glasses are mandatory.

These concise installation instructions are intended to help you get started quickly during installation. However, it is important to first read the full technical data sheet and to take note of the safety data sheets. It is also useful to read the technical information “working with epoxy”. You can find all these documents at the bottom of this page under downloads.