TERRA-GOLD

Tools

• drill with mixing spindle attachment
• flat trowel:
• plant sprayer
• gloves
• compulsory mixer or mixing tub

Mixing

• check you have sufficient material (for consumption, see label)

Mix

• Stir the resin using a drill with mixing spindle attachment
• Combine the A and B component in the correct proportion (see label)
  • • Weigh A and B component in separate buckets and then combine them. Always allow the mixing bucket to drain in between Always allow the mixing bucket to drain in between.
• mix for 2 minutes using a drill with mixing spindle attachment
• Place the granules in a mixing tub or compulsory mixer, add the mixed epoxy as quickly as possible and mix again

Apply

• Place small mounds and spread out immediately
• Spread on floor and spread immediately
• If necessary, remove excess resin from the tub
• Compress well

Additional points of attention

• Empty packaging: cured material or if scraped => construction waste, otherwise => chemical waste
• Cleaning tools with acetone

Additional points of interest

• Note: always mix for the same amount of time (chronometer), this will prevent any staining due to more or less erosion on the grains.
• Note: if the resin concentration is too high, the resin may foam up after a few minutes, or even after a few hours. You can avoid this by:
  • • after waiting a while, applying some excess resin from the bottom of the tub, mixer, wheelbarrow, etc. Always remove this immediately.
    • Do not pause after mixing so the resin does not have time to settle
    • if the gravel-resin mixture has stood still for more than 5 minutes, remix it
• Note: If the resin comes into contact with (excess) water too early, the resin may foam up after a few minutes, or even after a few hours. You can avoid this by:
  • • never use damp gravel (never leave the gravel out in the rain because the micro pores in the plastic bags allow water to enter the bag
    • do not use excess water to wet the trowel
    • always work on a dry surface
    • try to avoid rain getting on the floor for at least 1 hour after application
• Note: If the granulates are damp, (white) tinges will appear in the floor, and it will not be possible to remove them

Video

Disclaimer

These brief installation instructions are here to get you started quickly during installation. However, it is important to read the full technical sheet beforehand and take note of the safety sheets. Both documents can be found at the bottom of this page under downloads.